Lenovo ThinkAgile HX2320 Appliance, Руководство пользователя

Страница: 65 / 100

Figure 26. RAID adapter removal
Step 1. Slide the left-side latch to the unlocked position.
Step 2. Push and hold the right-side latch in the direction as shown.
Step 3. Grasp the RAID adapter by its edges and carefully remove it from the RAID adapter slot on the
system board.
Install a new RAID adapter. See “Install the RAID adapter” on page 61.
If you are instructed to return the old RAID adapter, follow all packaging instructions and use any packaging
materials that are provided.
Install the RAID adapter
Use this information to install the RAID adapter on the system board.
“ Read the
installation
Guidelines” on
page 39
“ Power off
the server
for this task”
on page 31
“ ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 41
Before installing the RAID adapter:
1. Touch the static-protective package that contains the new RAID adapter to any unpainted surface on
the outside of the server. Then, take the new RAID adapter out of the package and place it on a static-
protective surface.
2. If the new RAID adapter is installed with a bracket, remove the bracket.
To install the RAID adapter on the system board, complete the following steps:
Chapter 8
.
Hardware replacement procedures
61