Lenovo System x3750 M4, Инструкция по установке и обслуживанию

Страница: 190 / 982

Step 1. Turn on the server.
Step 2. When the prompt
<F1> Setup
is displayed, press F1. If you have set both a power-on password
and an administrator password, you must type the administrator password to view the event logs.
Step 3. Use one of the following procedures:
• To clear the IMM system-event log, select System Event Logs-->Clear System Event Log .
POST
When you turn on the server, it performs a series of tests to check the operation of the server components
and some optional devices in the server. This series of tests is called the power-on self-test, or POST.
Note: This server does not use beep codes for server status.
If a power-on password is set, you must type the password and press Enter (when you are prompted),
for POST to run.
If POST detects a problem an error message is displayed. See Appendix C “UEFI/POST error codes” on
page 479 for more information.
If POST detects a problem, an error message is sent to the POST event log, see “Event logs” on page
173 for more information.
Dynamic System Analysis
Lenovo Dynamic System Analysis (DSA) collects and analyzes system information to aid in diagnosing
server problems.
DSA collects the following information about the server:
• Drive health information
• Event logs for ServeRAID controllers and service processors
• Hardware inventory, including PCI and USB information
• Installed applications and hot fixes (available in DSA Portable only)
• Kernel modules (available in DSA Portable only)
• Light path diagnostics status
• Network interfaces and settings
• Performance data and details about processes that are running
• RAID controller configuration
• Service processor (integrated management module) status and configuration
• System configuration
• Vital product data and firmware information
For system-specific information about the action that you should take as a result of a message that DSA
generates, see Appendix B “DSA diagnostic test results” on page 319.
If you cannot find a problem by using DSA, see “Solving undetermined problems” on page 198 for
information about testing the server.
Note: DSA Preboot might appear to be unresponsive when you start the program. This is normal operation
while the program loads.
176
Lenovo System x3750 M4 Installation and Service Guide