Lenovo Storage N3310, Руководство пользователя и руководство по техническому обслуживанию аппаратного обеспечения

Страница: 50 / 152

2. On the Boot Sequence submenu under the Boot Manager menu, follow the instructions on the
screen to set the startup device for Boot Option #1 to Boot Option #5 depending on your needs.
You also can set the boot priority for various devices. See “Boot Manager menu” on page 33.
3. Press F10 to save settings and exit the Setup Utility program. The storage product will follow the
startup device sequence you have set each time you turn on the storage product.
Setting an Ethernet connector for system management
There are three RJ-45 Ethernet connectors on the rear of the storage product. The Ethernet connector 0 is for
system management by default. However, you also can set the Ethernet connector 1 for system management
use. To locate the three Ethernet connectors, see “Rear view of the storage product” on page 17.
To set the Ethernet connector for system management, do the following:
1. Start the Setup Utility program. See “Starting the Setup Utility program” on page 31.
2. On the TSM Settings menu, select TSM Network Settings ➙ TSM NIC Selection .
3. Do one of the following:
• To set the Ethernet connector 0 for system management, select Dedicated Port .
• To set the Ethernet connector 1 for system management, select Shared NIC Port .
4. Press F10 to save settings and exit the Setup Utility program.
Exiting the Setup Utility program
After you finish viewing or changing settings, press Esc to return to the Setup Utility program main interface.
If you are on a nested submenu, press Esc repeatedly until you reach the main interface. Then, you can do
one of the following to exit the Setup Utility program:
• If you want to save the new settings and exit the Setup Utility program, press F10 or select Save & Exit ➙
Save Changes and Reset . Otherwise, your changes will not be saved.
• If you do not want to save the new settings, select Save & Exit ➙ Discard Changes and Exit .
• If you want to return to the default settings, press F9 or select Save & Exit ➙ Load Optimized Defaults .
For more information about the Save & Exit menu in the Setup Utility program, see “Save & Exit menu”
on page 33.
Updating or recovering the BIOS
This topic provides instructions on how to update the BIOS and how to recover from a POST and BIOS
update failure.
Lenovo might make changes and enhancements to the BIOS and TSM firmware. When updates are
released, they are available for download on the Lenovo Web site at http://www.lenovo.com/drivers. You can
update the storage product firmware by downloading an update package and following the instructions
on the Web page.
Updating (flashing) the BIOS
This topic provides instructions on how to update (flash) the BIOS.
Notes:
• Update the BIOS on your storage product only if the newer BIOS version specifically solves a problem
you have. We do not recommend BIOS updates for storage products that do not need them. You can
view the updated information for the new BIOS version in the installation instructions for the BIOS
update utility program.
36
Lenovo Storage N3310 User Guide and Hardware Maintenance Manual