Lenovo RackSwitch G7000, Руководство по установке

Страница: 15 / 42

Chapter 2. Installing and removing the redundant power
supply
This chapter describes how to install and remove the redundant power supply in the following racks:
• Installing and removing the redundant power supply in a standard equipment rack
• Installing and removing the redundant power supply in a Lenovo System x or IBM Power rack
Before installing the redundant power supply
Locate and record the important product information about the G7000 unit in the following table. The
identification label (bottom of unit) contains the product name, serial number, and part number for the G7000
unit. The following illustration is an example of the serial number label. It may differ slightly from the G7000
identification labels.
After installed most of the identification labels are hidden from view and require removing the unit in order to
relocate them.
Attention: This product information is required to register your product, place a service call, and replace the
unit.
After the redundant power supply is installed most of the labels are hidden from view and require removing
the unit in order to relocate them.
Record this information below and print this page and keep it in a safe place for future reference. You will
need this information when you register the redundant power supply or open a service call. You can register
the redundant power supply at
http://www.ibm.com/support/mysupport/
.
Product name Lenovo RackSwitch G7000 Redundant Power Supply
Serial number
_____________________________________________
Part number
_____________________________________________
Required tools
You need the following tools or equipment to install the redundant power supply:
• Standard flat-blade screwdriver
• #2 Phillips screwdriver
• Electrostatic discharge wrist strap
Package contents
Note: The illustrations in this document might differ slightly from your hardware.
© Copyright Lenovo 2015, 2017
7