Lenovo Lenovo 3000 J Series, Руководство по техническому обслуживанию аппаратной части

Страница: 64 / 240

Diagnostic Error Code FRU/Action
001-032-XXX
System Device Controller failure
System board
001-034-XXX
System Device Buffer Allocation failure
1. Reboot the system
2. Flash the system. See “Flash update
procedures” on page 227
3.
Run memory test
4. System board
001-035-XXX
System Device Reset condition detected
System board
001-036-XXX
System Register error
System board
001-038-XXX
System Extension failure
1. Adapter card
2.
System board
001-039-XXX
System DMI data structure error
1. Flash the system. See “Flash update
procedures” on page 227
2.
System board
001-040-XXX
System IRQ failure
1. Power-off/on system and re-test
2. System board
001-041-XXX
System DMA failure
1. Power-off/on system and re-test
2. System board
001-195-XXX
System Test aborted by user
Information only
Re-start the test, if necessary
001-196-XXX
System test halt, error threshold exceeded
1. Press F3 to review the log file
2. Re-start the test to reset the log file
001-197-XXX
System test warning
1.
Make sure the component that is called
out is connected and/or enabled. See
Chapter 6, “Using the Setup Utility,” on
page 51
2. Re-run test
3. Replace the component that is called out
in warning statement
4. Replace the component under test
001-198-XXX
System test aborted
1. If a component is called out, make sure
it is connected and/or enabled. See
Chapter 6, “Using the Setup Utility,” on
page 51
2. Flash the system and retest. See “Flash
update procedures” on page 227
3. Go to “Undetermined problems” on page
81
001-199-XXX
System test failed, cause unknown
1. Go to “Undetermined problems” on page
81
2. Flash the system and re-test
3. Replace component under function test
001-250-XXX
System ECC error
System board
58
Hardware Maintenance Manual