Lenovo D1212, Руководство по установке и обслуживанию оборудования

Страница: 57 / 154

Rack Mounting Rail Kit
Various sets of rack mounting rails are available for use in 19 inch rack cabinets. These rails have been
designed and tested for the maximum enclosure weight and to make sure that multiple enclosures may be
installed without loss of space within the rack. Use of other mounting hardware may cause some loss of rack
space.
Contact your supplier to make sure that suitable mounting rails are available for the rack you are to use.
2U12 and 2U24 Enclosures
1. Remove the rack mounting rail kit from the accessories box and examine for damage.
2. Use the procedure given below to attach the rack brackets to the rack posts (see Figure 39 “Securing
Brackets to Rail ” on page 37):
a. Set the location pin at the rear of the rail into a rear rack post hole. Attach the bracket to the rear rack
post: use the washers and screws supplied. Leave the screws loose.
b. Extend the rail to fit between the front and rear rack posts.
c. Attach the bracket to the front rack post using the washers and screws supplied. Leave the screws
loose.
d. Tighten the two clamping screws located along the inside of the rear section of the rack bracket.
e. Repeat the steps for the other side rail.
Figure 39. Securing Brackets to Rail
3. Install the enclosure into the rack as follows:
a. Lift the enclosure and align it with the rack rails.
b. Carefully insert the chassis slides into the rack rails.
Note: Ensure that the groove is hooked with the chassis on both side as shown in the above figure.
c. Push the chassis fully in.
Chapter 3
.
Installation
37