Lenovo 70LU, Руководство пользователя и руководство по техническому обслуживанию аппаратного обеспечения

Страница: 77 / 142

Figure 50. Removing the drive from the convertor kit
8. Flex two sides of the drive bracket to remove the storage drive from the drive bracket.
9. If needed, install a new slim optical drive and storage drive. See “Installing a slim optical drive and
storage drive into drive bay 5” on page 65.
10. If you are instructed to return the old drives, follow all packaging instructions and use any packaging
materials that are supplied to you for shipping.
Installing a slim optical drive and storage drive into drive bay 5
Note:
For a 2.5-inch hard disk drive or solid-state drive, install the drive into a 2.5-inch to 3.5-inch drive
adapter first. See “Installing a 2.5-inch drive into a 2.5-inch to 3.5-inch drive adapter” on page 45.
To install a slim optical drive and storage drive into drive bay 5, do the following:
1. Prepare your server. See “Preparing your server and removing the server cover” on page 41.
2. Remove the front bezel. See “Removing the front bezel” on page 42.
3. Slide the slim optical drive into the HDD and slim ODD convertor kit until it snaps into position.
Figure 51. Installing the slim optical drive into the convertor kit
4. Flex the sides of the storage-drive bracket and align pins 1 , 2 , 3 , and 4 on the bracket with the
corresponding holes in the storage drive. Do not touch the circuit board 5 on the bottom of the storage
drive.
Chapter 5
.
Replacing hardware
65