Lennox VEP034N432US, Руководство пользователя

Страница: 38 / 44

DC Inverter Multi VRF System
34
Problems Causes What to do
Too many heat resources in the room. Reduce heat resources.
Filter is blocked and dirty. Clean the filter.
NOTE:
If problem cannot be solved after checking the above items, please contact
LENNOX
service center
and describe the cases and models.
(2) Following circumstances are not malfunctions.
Malfunction Reason
Unit doesn’t run.
Unit starts up immediately after it is turned
off.
Overload protection switch makes it run after a
3-min delay.
Power is just turned on. Standby operation lasts for about 1min.
Mist comes from
the unit.
Under cooling. Indoor air with high humidity is cooled rapidly.
Noise is emitted.
Slight cracking sound is heard when unit is
just turned on.
It is the noise when electronic expansion valve is
initialized.
There is consecutive sound when cooling.
It is the sound for gas refrigerant flowing in the
unit.
There is sound when unit starts or stops. It is the sound when gas refrigerant stops flowing.
There is slight and consecutive sound
when unit is running or after running.
This is the sound of drainage operation.
Cracking sound is heard when unit is
running or after running.
This is the sound caused by the expansion of
panel and other parts of the unit due to
temperature change.
Unit blows out
dust.
Unit starts up after not operating for a long
time.
Dust in indoor unit is blown out.
Unit emits odor. Under operation. Unit absorbs the room odor and then blows it out.
7 Error Indication
Inquiry method of error indication: combine division symbol and content symbol to check the
corresponding error.
Indoor:
Error Code Content Error Code Content
L0 Malfunction of IDU (uniform) d1 Indoor PCB is poor
L1 Protection of indoor fan d3
Malfunction of ambient temperature
sensor
L2 Auxiliary heating protection d4
Malfunction of entry-tube temperature
sensor
L3 Water-full protection d5 Malfunction of middle temperature sensor
L4 Abnormal power supply for wired controller d6
Malfunction of exit-tube temperature
sensor
L5 Freeze prevention protection d7 Malfunction of humidity sensor
L6 Mode shock d9 Malfunction of jumper cap
L7 No main IDU dA Web address of IDU is abnormal
L8 Power supply is insufficient dH PCB of wired controller is abnormal
L9 1-to-more: number of IDU is inconsistent dC
Setting capacity of DIP switch code is
abnormal
LA t1-to-more: IDU series is inconsistent dL
Malfunction of air outlet temperature
sensor
LH Alarm due to bad air quality (Fresh air unit) dE Malfunction of indoor CO
2
sensor
LC IDU is not matching with outdoor unit db Debugging status