Lennox LICH4024180P431-C, Руководство пользователя

Страница: 9 / 18

Care And Maintenance
Page 9
Care And Maintenance
6. Rinse the filter with clean water and allow it to air-dry.
DO NOT let the filter dry in direct sunlight.
7. Reinstall the filter.
8. Reinstall the front grille and reconnect the display panel
cable to the control box on the main body.
Repairing Refrigerant Leaks
WARNING
• If the refrigerant leaks, turn off the air conditioner
and any combustible heating devices, ventilate the
room and call your dealer immediately. Refrigerant
is both toxic and flammable.
DO NOT
use the air
conditioner until the leak is repaired.
• When the air conditioner is installed in a small room,
measures must be taken to prevent the refrigerant
concentration from exceeding the safety limit in
the event of refrigerant leakage. Concentrated
refrigerant causes a severe health and safety threat.
Refrigerant Leak Detection System (some models)
• In the event of a refrigerant leak, the LCD screen will
display “EC” and the LED indicator light will flash.
Preparation For Periods Of Non-Use
Maintenance after Extended Non-Use
1. Remove any obstacles blocking the vents of both the
indoor and outdoor units.
2. Clean the air filter and the front grille of the indoor
unit. Reinstall the clean, dry air filter in its original
position.
3. Turn on the main power switch at least 12 hours prior
to operating the unit.
Storing the Unit While Not In Use
1. Run the appliance on FAN mode for 12 hours in a
warm room to dry it and prevent mold.
2. Turn off the appliance and unplug it.
3. Clean the air filter according to the instructions in the
previous section. Reinstall the clean, dry filter before
storing.
4. Remove the batteries from the remote control.
NOTE: Some models include an auto-lifting panel
function, which allows the grill to move vertically and
simplifies the filter cleaning process.
4. Remove the air filter.
5. Clean the air filter by vacuuming the surface or
washing it in warm water with mild detergent.
A. If using a vacuum cleaner, the inlet side should face
the vacuum.
Fig. 4.3
B. If using water, the inlet side should face down and
away from the water stream.
Fig. 4.4
Fig. 4.2