Lennox Comfair HD, Руководство по установке, эксплуатации и техническому обслуживанию

Страница: 8 / 18

7
NAMES AND FUNCTIONS OF THE PARTS
1 TRANSMISSION INDICATOR LIGHT
This indicator light shows when a command has been
sent to the appliance.
2 TIME DISPLAY
This indicates both the current and the set time (AM,
PM, from 1:00 a 12:59).
3 OPERATING MODE DISPLAY
This shows the mode of operation (cooling,
dehumidifying, etc.).
4 TIME SETTING DISPLAY
This shows the time which the appliance should start
operating.
5 TEMPERATURE SETTING DISPLAY
This shows the thermostat setting.
6 FAN SPEED DISPLAY
This shows the current fan speed.
7 NIGHT AND AIR CLEANING FUNCTION DISPLAY
This shows that the night and negative ion generation
functions have been set.
8 TIMER MODE DISPLAY
This shows the current time, timer off, timer on.
REMOTE CONTROL DISPLAY
The illustration shows the control display with all the indicator lights
lit; only the currently request indicator lights, however, displayed
upon actual use.
- The signals will not be transmitted correctly if a wall, curtain or other objects are situated between the FAN COIL and the remote
control.
- The fancoil could operate incorrectly if strong light falls directly on the signal receiver. Use a curtain to protect from direct sunlight
and place any lamp with a strong light far from the signal receiver.
- If there is another electronic appliance operating by remote control, move it or contact the authorised after-sales service.
- Do not put the remote control in a place where it could be exposed to direct sunlight or near heating appliances.
- Protect the remote control against heavy impact and do not allow water or other liquids to be sprayed onto it.
- When the remote control is used in rooms where there are quick start lamps, the FAN COIL may not receive the signals correctly.
ATTENTION!
PREPARATION
1 Make sure that the unit is connected to the electricy
supply.
2 Open the front cover
3 Put the power switch to on
4 Close the front cover
POWER SUPPLY
1 Use both hands to pull the button edge of the front cover
forwards by 30°
2 Use both hands to push the front cover upwards, raising
it.
OPENING AND CLOSING THE FRONT COVER
2
1
ON - OFF
Don't operate the unit with the front cover open, since
malfunctioning could occur.
Fit the hooks located at the top of the base unit into the holes in the top of the front cover grille and then press the
bottom of the cover on both sides to lock it into place.
INSTALLATION
- OPERATING &
MAINTENANCE
MANU A L
Page 6