Lennox Comfair HC, Руководство по эксплуатации

Страница: 19 / 24

USING THE APPLIANCE WITH CONTROL PANEL
If the appliance has a built-in control panel, raise the flap and proceed as follows.
Heating mode
Put the season selector switch from the off position ( ) to the winter position ( ).
The fan starts.
In models with minimum temperature thermostat (optional), the fan starts when the internal heat exchanger is sufficiently
hot. If the water is not hot enough, the fan does not start.
Cooling mode
Put the season selector switch from the off position ( ) to the summer position ( ).
The fan starts immediately.
Selecting the fan speed
Put the selector switch to the required speed. The higher the speed the quicker the room will be heated/cooled, although
appliance operation will be noisier (fig. 40).
Automatic temperature adjustment (for control panel with built-in thermostat)
This control panel has a built-in temperature sensor, which measures the room air temperature. This information is
used for the automatic control of the fan or introduction of water into the internal exchanger through the solenoid valve
(optional). The appliance thus keeps the room at the temperature set by the user.
The room temperature may be set approx. between 10°C and 30°C. If the appliance does not have a built-in
control panel, but is controlled by a wall-mounted thermostat, refer to the thermostat instructions for use.
CONTROL PANEL WITH THERMOSTAT
BASIC CONTROL PANEL
Fig. 39
!
Fig. 41
Turn the knob towards the symbol +
to raise the temperature
Turn the knob towards the symbol -
to lower the temperature
Minimum speed Medium speed Maximum speed
Fig. 40
INSTALLATION
- OPERATING &
MAINTENANCE
MANU A L
Page 17