Page 4
),*85(
l
l
l
6(59,&( &/($5$1&(6 )25 &+3 81,76
723 &/($5$1&( ,6 l
%27720 &/($5$1&( ,6 l
5(7851
6833/<
)5217
5($5
/()7
5HDU FOHDUDQFH LV l ZLWK RU l ZLWKRXW DQ HFRQRPL]HU
l
5,*+7
5,**,1* $1' 6(77,1* 81,7
Exercise care when moving the unit. Do not remove
any packaging until unit is near the place of installa-
tion. A sling assembly may be used to lift unit. Spread-
ers whose length exceeds the largest dimension
across unit MUST be used across the top of the unit.
&$87,21
%HIRUH OLIWLQJ D XQLW PDNH VXUH WKDW WKH ZHLJKW LV
GLVWULEXWHG HTXDOO\ RQ WKH FDEOHV VR WKDW LW ZLOO OLIW
HYHQO\
Units may also be moved or lifted with a forklift while
still in the factory supplied packaging.
LENGTH OF FORKS MUST BE A MINIMUM OF 42.
127( 'R QRW SHUPLW RYHUKDQJLQJ VWUXFWXUHV RU VKUXEV WR
REVWUXFW FRQGHQVHU DLU GLVFKDUJH RXWOHW RU LQOHW
The unit is designed to be located outdoors with suffi-
cient clearance for free entrance to the air inlet and dis-
charge. Location must also allow for adequate service
access.
The unit must be installed on a solid foundation that
will not settle or shift. Adequate structural support
must be provided. Maintain minimum clearances as
shown in illustration and install unit in level position.
Isolate the base from the building structure to avoid
possible transmission of sound or vibration into condi-
tioned space.
Unit foundation should be raised to a minimum of 3
above finish grade. In areas which have prolonged pe-
riods of temperature below freezing and snowfall, the
unit should be elevated above the average snow line.
Also extra precaution should be taken to allow free
drainage of condensate from defrost cycles to prevent
ice accumulation. Unit should not be located near
walkways to prevent possible icing of surface from de-
frost condensate.
Avoid placing unit near quiet areas, i.e. sleeping quar-
ters or study rooms. Normal operating sound levels
may be objectionable if the unit is placed near certain
rooms.
&21'(16$7( '5$,1
The CHP29 heat pump is equipped with a 3/4 fpt cou-
pling for condensate line connection. The drain line
must be properly trapped and routed to a suitable
drain. See illustration for proper drain arrangement.
The drain line must pitch to an open drain or pump to
prevent clogging of the line.
81,7
0LQLPXP 3LWFK
l PP SHU
P RI OLQH
02817,1*
)5$0(
),*85(
23(1
9(17
7UDS PXVW EH GHHS HQRXJK WR RIIVHW PD[LPXP
VWDWLF GLIIHUHQFH *HQHUDOO\ LQFKHV PLQLPXP
7<3,&$/ &21'(16$7( '5$,1
),/7(56
There are no filters supplied with the unit. Filters must
always be installed ahead of evaporator coil and must
be kept clean or replaced. Dirty filters will reduce the
airflow of the unit. Filters should be sized in accordance
with Table 2 below.
7$%/(
&+3 81,7 ),/7(5 6,=(
CHP29 UNIT MODEL
FILTER SIZE
--024, --030, --036
24 X 25
--042
28 X 25
--048, --060
30 X 30
