background image

# 41718L098

Page 1

Save these instructions for future reference

INSTALLATION AND MAINTENANCE

INSTRUCTIONS

SCU Series

Split System Air Conditioner

Manufactured By

A.A.C.

A Lennox International Company

421 Monroe Street

Bellevue, OH 44811

TABLE OF CONTENTS

INSTALLATION....................................... 2

START-UP .............................................. 5

MAINTENANCE ..................................... 5

WIRING DIAGRAMS .............................. 6

WARRANTY ........................................... 8

Before performing maintenance operations on
system, turn off all main power switches to
indoor and outdoor units.  Turn off accessory
heater power switch if applicable.  Electrical
shock could cause personal injury or death.

  WARNING

Installation and servicing of air conditioning
equipment can be hazardous due to internal
refrigerant pressure and live electrical compo-
nents.  Only trained and qualified service
personnel should install or service this equip-
ment.  Installation and service performed by
unqualified persons can result in property
damage, personal injury or death.

  WARNING

Risk of electrical shock.  Disconnect all remote
power supplies before installing or servicing
any portion of the system.  Failure to discon-
nect power supplies can result in property
damage, personal injury or death.

  WARNING

The equipment covered in this manual is to be installed by trained and experienced
service and installation technicians.  Improper installation, modification, service or use
can cause electrical shock, fire, explosion or other conditions which may cause per-
sonal injury, death or property damage.  Use appropriate safety gear including safety
glasses and gloves when installing this equipment.

 

WARNING

Содержание 41718L098









Отзывы: