NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
25
Glowing Embers
Bag of Glowing
Embers (rockwool)
Separate into Quarter
Size (separate) Pieces
Locating Pins - 5 Places
Log Support Bracket
Firebox
Ember Burner Ports
LOG SET
Catalog Number
H127
* Item
Description
A
Log, Rear
B
Log, Left Middle
C
Log, Right Middle
D
Log, Left Front
E
Log, Right Front
* Item "letters" above correspond to photos
D
C
A
B
E
Figure 41 - Log Set and Glowing Embers
Step 8. Install the firebox liner kit (sold separately), per instruc-
tions provided in kit, before proceeding to Step 9.
Step 9. INSTALLING THE LOGS AND GLOWING EMBERS
A FIREBOx LINER KIT MUST BE INSTALLED BEFORE INSTALLING LOGS.
THIS APPLIANCE IS NOT APPROVED FOR OPERATION WITHOUT A
FIREBOx LINER KIT INSTALLED (SOLD SEPARATELY). SEE PAGE 12
IN CARE AND OPERATION MANUAL FOR ORDERING INFORMATION.
INSTALL LINER KIT AND LOG SUPPORT BRACKET PER INSTRUCTIONS
PROVIDED IN KIT.
The logs are packaged in a carton located within the firebox. One plastic
bag of glowing embers is located in the bottom compartment. Refer
to the
Log Set Placement Instructions
(Figures 41 to 47)
for detailed
placement instructions for the logs and glowing embers.
Proper log and ember placement is critical to encourage outstanding flame
appearance and prevent sooting. These fires are designed to provide a
rich orange/red glow on the logs.
Note: Log setup is by design asymmetric. The fire is intentionally posi-
tioned off center to provide a natural fire look.
WARNING
•
DO NOT attempt to install the logs until the
appliance installation has been completed, the
gas line connected and tested for leaks and the
initial burner operation has been checked out.
•
Logs get very hot and will remain hot up to one
hour after gas supply is turned off. Handle only
when logs are cool. Turn off all electricity to the
appliance before you install logs and embers.
•
This appliance is not designed to burn wood.
Any attempt to do so could cause irreparable
damage to the appliance and prove hazardous
to your safety.
•
If logs are not installed according to the log
installation instructions, flame impingement
and improper combustion could occur and result
in soot and/or excessive production of carbon
monoxide (CO), a colorless, odorless, toxic
gas.
•
The size and position of the log set was engi-
neered to give the appliance a safe, reliable
and attractive flame pattern. Any attempt to use
a different log set in the fireplace will void the
warranty and will result in incomplete combus-
tion, sooting, and poor flame quality.
Complete the following before starting the log installation.
• READ WARNINGS ON THIS PAGE BEFORE PROCEEDING
•
Remove the front glass enclosure panel
(see
Glass Enclosure Panel
Removal Instructions
,
Page 23).
•
Remove the log set from the firebox and the bag of embers from the
control compartment. Handle logs carefully to prevent breakage.
1
2
4
5
This appliance is provided
with enough Glowing Em-
bers for several applica-
tions, do not use all that is
in a new bag at one time.
For best glowing effect,
replace the ember material
annually.
