~ 11 ~
Playing a Disc
1. Make sure the Player has the power either from the battery
or the AC adaptor.
2. Load a disc, following these steps:
Open the top cover.
Press the
OPEN
button to open the disc cover.
Place a disc into the tray with the label side facing up.
Close the disc cover.
3. Slide
POWER
to
ON
to turn on the power.
Preparation for Playback
1. Press on the player to temporarily stop the playback, " "
appears on the screen.
2. Press again to stop the playback.
Stop
You can skip chapters on DVD-Video, tracks on CDs, and
Video CDs.
1. To skip forward, press during play ,it skips to the next
chapter or track. Each press increases the number of skips.
2. To skip to the previous chapter or track, press .
Skip
1. During playback, to fast forward, repeatedly press to
increase the fast forward speed 2x, 4x, 8x, 16x, 32x.
2. During playback, to fast rewind, repeatedly press to
increase the fast reverse speed 2x, 4x, 8x, 16x, 32x.
3. To resume normal playback, press .
Fast Forward and Reverse
Adjusting volume
Play
Press (on the remote control) or (on the player) to
start play.
Resume
There are two ways to resume playback when interrupted.
Method 1.
-- for short time interruption
1. Press
STOP
( ), the Player remembers where you stopped.
Method 2.
-- for long time interruption
2. To resume, press , the Player will play from where you
stopped.
Press
VOL+
or
VOL-
(on the remote control) to change volume
and you can also use the VOLUME control dial on the Player
to change volume .
1. During playback, press (on the remote) or (on the
player) to pause.
2. Press (on the remote) or (on the player) to resume
playback.
Pause
1. Enable the last memory in the setup menu.
2. Press OPEN to open the disc compartment door while the
Player is playing.
3. You can turn off the power, and even remove the disc from
the desk, when you turn on the power and replace the disc,
the Player will play from the point when the door was
opened.
