7
Getting started
Where to install
Never place the tower in direct sunlight. For comfortable viewing, we recommend a soft light.
Place it on a sturdy platform of which the surface should be flat and steady, so the product
can’t fall or hit by any objects. Make sure the product is placed in such a manner that nothing
can fall on top of it, as pressure will damage or break the product. Prevent insertion of
objects into the ventilation slots, or openings in the cabinet at all time.
Connecting the power cord
Connect the power cord to the tower by connecting the small flat end of the cable to the
power connection on the rear of the tower. Connect the wide flat end of the cable to the
power outlet.
The power outlet must be easily accessible, so that the power cord can be easily
disconnected from the outlet when there is a problem with the device.
Installing the batteries in the remote control
1. Press the locking tab in the direction of the arrow.
2. Pull out the battery tray in the direction of the arrow.
3. Place the battery in the tray with the + side facing up.
4. Push the tray back into the remote until it clicks.
Important note
: Only use a battery of type CR2025.
Battery maintenance
To maximize the battery and remote control lifetime, please follow these instructions:
Use the remote control of the product at least once a week.
Remove the battery from the remote control if it is not used longer than a week.
Always keep the tablet away from heat sources.
Lenco recommends the use of A-brand batteries.
Installing the backup memory battery
Open the battery compartment by pressing the cover in the direction of
the arrow.
Place the CR2032 battery and close the cover. Please note that the
battery should be placed in the same way as the original battery.
