11
ASSEMBLY INSTRUCTIONS
REMOVE THE BIKE AND COMPONENTS FROM THE SHIPPING CARTON
Move the box to the desired location. Ensure that the carton is standing upright and remove the
1.
strapping material.
Pull the cardboard edge out along the bottom of the box to remove the staples. Lift the top of the
2.
box up and set aside.
Remove the two smaller boxes from the main frame of the bike.
3.
Open both boxes and verify that you have all of the hardware and parts necessary to assemble your
4.
bike; you should have this owner’s manual, all the illustrated assembly parts, and all the necessary
tools.
ASSEMBLY
Note: It is not necessary to remove the bike from the foam shipping cradle before assembly.
M8 + star washer
M8 + curved washer
Align the front stabilizer (the one with the
1.
transport wheels) with the holes in the main
frame, below the flywheel.
Attach the stabilizer with two (2) M8 x 15
2.
mm screws and two (2) star washers above,
and two (2) M8 x 15 mm screws and two (2)
curved washers below. Tighten them with a
hex key
M8 + curved washer
M8 + star washer
Align the rear stabilizer with the holes in the
3.
main frame below the seat post
Attach the rear stabilizer with two (2) M8x15
4.
mm screws and two (2) star washers above,
and two (2) M8 x 15 mm screws and two (2)
curved washers below. Tighten them with a
hex key.
M8 x 15
Place the stretch pad on the rear stabilizer
5.
and back post of the frame. Attach with two
(2) M8 X 15 mm bolts and tighten them with
a hex key.
Содержание REvMaster
Страница 1: ...OWNER S MANUAL ...
