LEMAN PON306, Инструкция пользователя

Страница: 47 / 52

3. Position the exposed adhesive on the upper
half of the disc that extends above the table. Aligning Table
Once it is positioned evenly across the disc,
press the adhesive onto the surface.
The table must be aligned to the face of the sand-
4.
5.
Now rotate the disc so the lower half is now
above the table.
Bend the paper back and remove the
remaining half of the protective layer (
Figure
ing disc so that the sandpaper does not rub
against the table.
To align the table:
6 ), and then press this portion against the
1. Loosen the screws that secure the table to
disc.
2.
3.
4.
5.
the table support bracket.
Align the table so that there is a
1
⁄
16
'' gap
between the 12" disc and the table ( Figure
7 ).
Tighten the screws loosened in step 1 .
Spin the disc by hand to check if the sand-
paper is touching the table. Note—
DO NOT
turn the disc sander on at this point.
Repeat steps 1-3 if sandpaper touches table
at any point in the rotation.
Figure 6 . Removing protective layer.
Table Support
Screws
1⁄16 Gap
Figure 7. Table aligned with sanding disc.
-8-
EN