140528/2
Page
19
of
32
Ventilation exit
The main heat sink has an airflow exit centered on the back panel. Inlet holes
are on the side panel of the chassis.
CAUTION
: Do
not
block the airflow to/from the unit.
4.8
Transducer head
The transducer head is connected to the electronics rack using a dedicated
cable with a multi-pin bayonet-style connector. Various cable lengths are
available.
If the transducer head is programmable it also has a 25-pin D-Sub male UNC
4-40 screw lock connector. This connector is used with suitable programming
plugs (accessory) – for further information, please refer to section 4.5 for
further information on programmability.
CAUTION
: A programming plug
must
be connected to the programming port of a
programmable head when the system is powered.
!
!
