LELY Hibiscus 745 CD Vario, Руководство оператора

Страница: 32 / 64

4.3 Adjust the height of the wheel assembly
Procedure
1. Operate the tractor single-acting valves (system I and/or III) to lift the
rotors both or independently just above the ground or to the headland
position.
2. Stop the tractor.
3. Disengage the PTO.
Wait for all moving parts of the Hibiscus to stop.
Always switch off the tractor engine before you leave the tractor cab.
4. Switch off the tractor engine.
5. At the back of the wheel, remove the axle nut and the retaining ring
from the wheel axle.
6. Remove the wheel axle and included wheel from the wheel assembly
and install it in the required hole (fig. 17, page 4
‑
4).
7. Install the retaining ring and axle nut.
1. Wheel assembly - 2. Washer - 3. Nut
Figure 17. Adjust the height of the wheel assembly
WARNING
WARNING
4-4 Operation adjustments
R-H014-1210EN