Leitronic AG EA-8-WRL868, Инструкция по использованию, Страница: 9 / 40

9
5.2 Designation of the calling number sequence
5.2.1 Standard sequence
Alarm triggered Calling number 1
Alarm not acknowledged
by called party 1
Calling number 2
alarm not acknowledged
by called party 2
same for calling number 3 to 9
The alarm is acknowledged by pressing DTMF 0 (

section 6.7.5).
5.2.2 How to program calling number sequence
1. Slide function switch to PROG
2. Enter * * 0 .

Current calling number sequence will be announced followed by “to modify press star“
3. To maintain the current programming, go to point 5. Otherwise enter
* .
.
4. Enter the desired sequence (max. 9 digits)
5. Slide
function switch to OFF
Sample for programming calling number sequence:
a)
’123’ => calling number 1 will be dialled, followed by calling number 2, followed by calling number 3.
b) ’111133322’ => first calling number1 will be dialled (4 call attempts are made), followed by calling
number 3 (3 call attempts are made), followed by calling number 2 (with 2 call attempts).
Notes:

The calling number sequence is factory set to ’123456789’, but a general reset will NOT RESET the
calling number sequence!

In case of an un-programmed or deleted calling number, the calling number sequence will continue with the
next number of the sequence.

If a dialled number is busy and another call attempt is programmed, the waiting period before re-dialling is
30 sec.

If the calling number changes within the sequence, dialling of a new number starts without delay.

You can demand the difference alarm sequence in each selection switch ((I/II/III), this typical of alarm
sequence definite in (

section 9.9)
5.3 How to select user language / How to record individual message
An individual announcement can be recorded as follows:
1. Shift function switch to PROG
2. Enter * * # .

Current individual message will be announced followed by “to modify press * , to stop press # “
3. Select language for user announcements: (facultative)
Press key
1
to
4
according to desired user language (i.e. 1=DE/2=FR/3=GB/4=IT)
4. Press * and start speaking
5. Press
#
to finish recording, max. duration is 12 seconds

New individual message will be announced
6. Shift function switch to OFF
Note:

Repeat step 3 and 5 until you are satisfied with individual message.
5.3.1 Remote recording of individual message during handsfree connection
1. Enter DTMF * * # #

Current individual message will be announced followed by “to modify press * , to stop press # “
2. Select language for user announcements: (facultative)
Press DTMF 1 to DTMF 4 according to desired user language (i.e. 1=DE/2=FR/3=GB/4=IT)
3. Start recording by sending DTMF * , start talking (max. 12 s) and finish by sending DTMF # .

New individual message will be announced
4. Wait until the message “Abort” confirms the end of the programming
Note:

Remote recording can be enabled / disabled according to section 9.8.1.
if called party 3 does not acknowledge the alarm, the calling
number sequence is repeated the number of programmed
alarm repetitions times (
default value: two alarm
repetitions , programming see section 9.2)