Rev. A 1-2-2015
PAGE 2 OF 2
1)
ATTACHE TWO RTT BRACKETS TO THE INSIDE
FRONT AND INSIDE REAR CROSS BEAMS USING 8
T-BOLTS. LOSSLY TIGHTEN WITH M8 LOCKNUTS
SO THAT THE BRACKETS CAN STILL SLIDE. (FIG
3)
2)
ADJUST THE BRACKEST AS SHOWN. THE
BRACKETS ARE STILL LOSE AND WILL BE
ADJUSTED IN A FUTURE STEP. (FIG 4)
3)
YOUR ROOF TOP TENT SHOULD HAVE SHIPPED
WITH 4 SLIDE PLATES. INSTALL THE SUPPLIED M8
X 20 SCREWS INTO THE SLIDE PLATE AND
INSTALL TWO INTO EACH TENT MOUNTING RAIL.
(FIG 5)
4)
USING A FORKLIFT (RECOMMENDED) OR 3 OF
YOUR STRONG FRIENDS LIFT THE ROOF TOP
TENT ONTO THE TOP OF THE RACK.
5)
LIFT EACH CORNER OF THE TENT AND POSITION
THE M8 X 20 CAP SCREWS INTO THE HOLE ON
THE RTT MOUNTING BRACKET. LOOSLY TIGHTEN
THE M8 NUTS ONTO THE M8 X 20 CAP SCREWS.
(FIG 6)
6)
CAREFULLY WALK AROUND THE VEHICLE AND
MAKE SURE THE TENT IS CENTERD ON THE RACK.
7)
TIGHTEN ALL THE M8 LOCKNUTS TO 16IN-LB.
8)
IS RECOMMENDED THAT YOU CHECK THE
TORQUE OF ALL THE BOLTS ON THE RACK AND
TENT FREQUENTLY TO INSURE EVERYTHING IS
TIGHT.
..
ATTACH RTT BRACKETS
1
(fig 4)
(fig 3)
M8 nut
T-bolt
RTT brackets
shown in
installed position
(fig 5)
M8 X 20
cap screw
Tent mounting
Rail
Slide plate
(fig 6)
M8
LOCKNUT
