Leitch AES6800+, Инструкция по установке и эксплуатации

Страница: 18 / 54

4 AES6800
+
Installation and Operation Manual
Preliminary—Contents are proprietary and confidential. Do not photocopy or distribute.
Chapter 1: Introduction
Figure 1-2 is a generic top-front view of a typical AES6800
+
C front
module, and shows the general location of LEDs and jumpers.
Figure 1-2. Typical AES6800
+
C Front Module
LEDs, Switches, and Jumpers
Table 1-1 briefly describes generic 6800
+
LEDs, switches, and
jumpers. See Chapter 2: “Installation and Configuration” for more
information on specific AES6800
+
module controls, LEDs, and
jumpers.
Table 1-1. Generic 6800
+
Module Features
Feature Description
Module status
LEDs Various color and lighting combinations of these LEDs
indicate the module state. See
Table 1-2 on page 5 and
“LEDs and Alarms” on page 25 or more information.
Control LEDs Various lighting combinations of these control LEDs
(sometimes referred to as “Bank Select LEDs”) indicate
the currently selected bank. (This item not available on
the AES6800
+
)
Monitoring
LEDs Each 6800
+
module has a number of LEDs assigned to
indicate varying states/functions. See “LEDs and
Alarms” on page 25 for a description of these LEDs.
Local/remote
control jumper
• Local : Locks out external control panels and allows
card-edge control only; limits the functionality of
remote software applications to monitoring
• Remote : Allows remote or local (card-edge)
configuration, operation, and monitoring of the
AES6800
+