Leisure's Edge LE 744, Руководство пользователя

Страница: 24 / 59

Page 22
For HELP, call 727.573.9611
the hot tub itself.
8. With the drain open and filters removed, thoroughly rinse out the hot tub with
warm water until the drained water runs clear. Run water through the
filtration canister and jet lines to remove any incidental dust, dirt, and debris
that may have accumulated during shipment or installation. Drain all water
completely.
9. Make sure that the hot tub drain valve is closed and the cap is on tight (see
page 43).
10. Install the filter(s) in the filtration canister.
11. Check that all of the
hot tub jets are open (turned full counter-clockwise).
12. Now is the best time to clean and polish the surfaces of your hot tub if you
wish (see page 35).
Filling Your Hot Tub
Now it's time to fill your hot tub with water. Do not turn on
the electricity yet until the hot tub is completely filled. To
properly fill your hot tub :
1. Make sure that the filters (in the filtration canister)
are gently screwed into place. Turn them clockwise
until they stop being careful not to over-tighten them
(this avoids cracking the filter).
2. Connect a standard garden hose to a faucet with
regular cold tap water (not softened water or hot
water).
Figure 17 – Filtration Canister
Caution: The water from your hot water tank should not be used to fill the hot
tub.
3. Put the pre-filter (if equipped
**
) on the other end of the hose, point the pre-
filter into a suitable drain, turn on the water, and allow any sediment to be
flushed down the drain. Once the water stream runs clear, turn off the hose.
4. Put the pre-filter (if equipped) into the filtration canister and turn on the hose.
5.
Fill slowly . If too much water pressure is used, foaming water can force air
into the pipes and cause startup problems.
Important: To assure that the pump is properly primed, fill the hot tub
through the filter area only .
6. Fill the hot tub until the water level is about 1” above all jets (or about ½”
below the pillow). Do not over fill.
Note : Every person entering a hot tub displaces a given volume of water, so
adjust water level to the number of people regularly using the hot tub.
**
Pre-filters are available by calling 727.573.9611