Leisure Works 1610636-1, Руководство пользователя

Страница: 21 / 26

20
CLEANING AND MAINTENANCE
Care has been taken to assure that your treadmill has been properly adjusted and lubricated at the factory. It is
not recommended that the user attempt service on the internal components instead seek service from an
authorized service center. However, from time-to-time the outer surfaces may appear dull or dirty, following the
instructions listed below will restore and preserve the original finish.
Note: Always unplug your treadmill prior to cleaning in order to avoid electrical hazard or shock.
1. Cleaning metal surfaces may be accomplished by using a soft cotton or terry cloth rag with a light
application of car wax. Do not use aerosol sprays or pump bottles as they may deposit wax upon the walking
or computer surface.
2. Under no circumstances are you to use ammonia, oils, silicones, or any other compounds on the rubberized
walking surface. The use of such materials may cause serious injury to the body and/or deteriorate the
performance of the walking surface. Only clean the rubberized walking surface with a damp cloth (water
only).
3. From time-to-time the computer surface may collect dust or finger prints. The use of harsh chemicals will
destroy the protective coating and cause a static build up that will damage the components. This surface may
be cleaned with specially prepared chemicals found in most computer supply stores especially made for anti-
static surfaces. It is strongly recommended that you purchase such a cleaning compound.
RESET SWITCH RESETTING
If your treadmill looses power or will not start, check the reset switch located on the front of the motor cover.
If the white tab of the reset switch is not showing then the reset switch has not been tripped.
If the white tab of the reset switch is showing, the reset switch has tripped.
To reset the reset switch:
Remove the safety clip on console.
Press white tab of the reset switch in until it snaps back into place.
If the reset switch continues to trip - see treadbelt adjustment and treadbelt lubrication
SPEED SENSOR ADJUSTMENT
If the monitor does not display speed or distance the speed sensor and magnet may be misaligned. Follow these
steps to check and realign.
Remove the motor cover
Check the spacing and alignment between the magnet on the right side of the front roller and the speed sensor
on the frame. The spacing must be 1/8”.
Loosened screw and slide speed sensor in or out of clamp.
Retighten screw
Replace the motor cover.