18
1 2
3 4
38
17
16
6
Installing the guide bar (1)
• Install the
guide bar (1)
using the
lever screw (20)
and set it to the desired position
Adding an auxiliary weight (15)
• Install the
weight holder base (22)
, plus any necessary
weight holder extensions (23)
, and place the
weights (15)
on the weight holders (max. seven auxiliary weights)
Adjusting the overlap guide (18)
The roller on the
overlap guide (18)
has 4 markings
Adjusting the starting switch
Release the
starting switch (38)
clamp, and move the starting switch as
required. Moving it to the left increases the starting delay, moving it to the
right reduces the starting delay. This increases or reduces the preheating
time at the start up.
Adjusting the round belt (16)
Check the position of the
round belt (16)
. The
round belt
(16)
must lie parallel to the
drive roller / contact
pressure roller (6)
. If
necessary, adjust the
tensioner (17)
for the round belt.
1
: Not used
2
: Marking 40, 30, 20 mm overlap (factory setting)
3
: Not used
4
: Marking tape 40 mm
