62
If the drive is switched off, then the welding parameters for temperature, air volume, and
speed are set as follows in the
display fields (42)
:
• Using the
Confirm key (40)
, you can set the cursor to the desired parameter.
• The values of the selected parameter can be adjusted using the
Minus/Plus keys
(39/41)
.
When the drive is switched on, the welding parameters are set in exactly the same way
and transferred immediately. The cursor automatically switches back to the drive speed
row 5 seconds after the entry has been made.
CAUTION!
Mechanical damage could occur if the maximum welding force of 1000 N is exceeded
Risk of crushing
There is a risk of crushing due to the movement of mechanical parts. Only hold on to the hot-air
welder at the handles provided.
Adjusting the welding force
When welding materials up to a thickness of 3 mm, the
welding force module (6)
on the TWINNY T5 prevents
an excessive welding force from being set. A smaller welding force is applied for thinner materials and a greater
force for thicker materials. The welding force can be increased or decreased slightly by rotating the
adjustment
ring (43)
. Proceed as follows to adjust the welding force:
• Unlock the
clamping lever lock (5)
and open the
clamping lever (4)
.
• Unlock the
adjustment ring lock (44)
.
• Rotate the
adjustment ring (43)
on the
welding force module (6)
. Rotating it in the "+" direction increases
the welding force and rotating it in the "–" direction decreases it. The
adjustment ring (43)
on the
welding
force module (6)
can be rotated by a maximum of 360°.
• Once the desired welding force has been set, lock the
adjustment ring lock (44)
again.
Clamping lever (4) open
Clamping lever (4) closed
4
4
4
5 44
6
43
Setting the speed, temperature, and air volume before welding
