9
6
6
7
7
8
9
1
1
1. First switch off the
toggle switch (7
). The
blower continues to run until either the
toggle
switch (6)
is switched off or the
power cord
(1)
is disconnected. As a result of the fact that
the blower continues to run separately after the
toggle switch (7)
has been switched off, a lag
in the air supply is generated and, as a result, the
heating element of the connected hand tool cools
down. This is recommended to extend the life of
the heating element.
2. We recommend a lag time of approx. 5 minutes.
3. Now switch off the
toggle switch (6)
.
4. After the blower has been switched off, disconnect
the
power cord (1)
from the mains.
1. Connect the hot-air welder with the appropriate
hose and hose clamps to the
hose connection (9)
(the hose must be fastened with hose clamps).
2. Once you have prepared the working area and the
blower in accordance with the description, connect
the blower’s
power cord (1) to the
mains voltage.
3. Now plug the mains cable of the handheld device
into the
socket (8
).
4. Switch the blower on using the
toggle switch
(6)
. The
toggle switch (6)
serves as the main
switch for the
AIRSTREAM 100.
In this switched
on state, the
AIRSTREAM 100
blower starts up
automatically.
5. The
socket (8)
is not supplied with power until
both
toggle switches (6 and 7)
are switched on.
Now also switch on the
toggle switch (7
).
6. Before adjusting the temperature on the connected
hot air device, make sure that there is enough air
escaping.
7.4. Switching off the blower
7.3. Switching on the blower
