Leica Captivate, Техническое справочное руководство

Страница: 571 / 1060

Description of fields
Field Option Description
Allow edit-
ing the
height of
the location
being
staked
Check box When this box is checked, the design height
can be changed manually for Height : From
line or Height : Start point of line .
Next step
Page
changes to the Design page.
On this page, additional design points to be staked are set. Refer to "41.6
Staking to a Line" for a graphic.
Description of fields
Field Option Description
Project to
segment of
stake posi-
tion
Check box When staking on offset line based on a poly-
line, there are situations where no valid off-
set information can be calculated and dis-
played. This situation appears at offset bisec-
ted points (BP).
When this box is checked, a line is defined to
orientate to so that stake values can be cal-
culated and displayed.
Segment to
use at Angle
Points
Back or
Forward
Refer to "Points of interest" for a diagram
showing angle points.
Defines if the segment used as reference for
the stakeout values is in backwards or for-
wards direction.
Horizontal
(PC, PT, AP)
Check box Horizontal type points occur at the junction
between two segments in a line.
Mid curve
(MCP)
Check box Occurs in arc segments.
Curve radius
(RP)
Check box Occurs in arc segments.
Offset
bisected
point (BP)
Check box Occurs when the junction between two seg-
ments in a line is not tangent AND when off-
sets are active.
Offset in
average
direction
(Avg)
Check box Occurs when the junction between two seg-
ments in a line is not tangent AND when off-
sets are active.
Vertical
(VPI, Low,
High, VPC,
VPT)
Check box Vertical type points occur at the junction
between two segments in the vertical align-
ment of the line, or when a high or low ele-
ment is found. Example: In a curve between
two grades
Settings,
Heights page
Settings,
Design page
Measure to line/Stake to line 571