Leica BIOSYSTEMS CM3600 XP, Инструкция по эксплуатации

Страница: 74 / 86

74
Version 6.9, Revision H
Operating the Leica CM3600 XP
7
7.10.3 Knife holder height adjustment
Fig. 83
1
1
2
2
• To adjust the knife holder on the support
columns (
→
Fig. 83- 1 ) , first unscrew both
clamping levers (
→
Fig. 82- 7 ) on the bottom
side.
• Afterwards, slightly unscrew the 4 knurled
screws ( → Fig. 82- 6 ) and loosen the other
two clamping levers.
Warning
Secure the knife holder so that it
does not fall down.
• Position the knife holder with the upper edge
for the groove (
→
Fig. 83- 2 ) in the support
columns in the 100 mm position or all the
way at the top for the 200 mm position, see
(
→
Fig. 85) .
• Then re-tighten the 4 clamping levers
(
→
Fig. 82- 7 ) and the four knurled screws
( → Fig. 82- 6 ) .
7.10.4 Uninstalling the knife holder
Warning
Before the knife holder can be uninstalled, the temperature sensor (
→
Fig. 84- 4 ) has to be
disconnected.
4
5
Fig. 84
• To loosen the temperature sensor, swing the
locking clip ( → Fig. 84- 5 ) to the bottom and
pull the sensor ( → Fig. 84- 4 ) out of the mount.
• To remove the knife holder, loosen the knurled
screws (
→
Fig. 82- 6 ) and clamping levers
(
→
Fig. 82- 7 ) , see (
→
p. 74 – 7.10.3 Knife
holder height adjustment) , then pull the knife
holder upwards and remove it.