INSTRUCTION MANUAL
AAL Profiline wireless socket
HC-503-BA V1.06 Wireless socket Page 1 of 4
AAL
Homecare
Fon +49 (0) 2208 9339170 Fax +49 (0) 2208 9339063 www.aal-homecare.com
Example: selection of compatible transmitters
Warning
The use of a call device does not release supervisors from the obligation to supervise the persons supported by
such a device. This system is radio-based and must therefore not be used for monitoring purposes if life-
threatening conditions are foreseeable.
Package Contents
Product
Order number
1
Frequency
1
AAL Profiline wireless socket
HC-503
869.23 MHz
Instruction manual
HC-503-BA
1
Order number and frequency can be found on the identification decal.
Note: While unpacking, each shipment should be inspected for completeness and damage.
Note: In this manual, the
AAL Profiline wireless socket
is referred to as “
wireless socket
”.
Fig. 1: wireless socket
Putting into Operation
Caution
The wireless socket must not be used as the only switching device of an electric device.
The wireless socket is not suited for switching high electric loads! Excessive switching currents may impair the life
of the internal switching contacts or result in a loss of breaking capacity. The
maximum
breaking capacity of
10 A
must on no account be exceeded!
Usage
Warning
The wireless socket is not intended for signalling personal emergency calls. Any use for the purpose of signalling
life-threatening conditions is not permitted.
Keep out of reach of children. The wireless socket is de-energised only when the plug is disconnected.
Programming / Deleting Transmitters to / from the Wireless Socket
The “programming” to the wireless socket required for initial putting into operation is described in Figs. 5 and 6, and the optional
“deletion“ from the wireless socket is described in Fig. 3.
Checking the Safe Range of the Radio Link
The range of the matching AAL
Profiline
transmitters meets the requirements of the technical inspection body of the German
health insurance companies. Within buildings, a range of approx. 30 m can be expected. The range depends to a large extent on
the local conditions.
Before using the device for the first time, an interference-free operation of the radio link should be ensured. Proceed as follows:
1. Switch
on
all electronic entertainment and communication devices (e.g., television sets, game consoles, and computers) in
the immediate vicinity.
2. Check if the radio message is received by the wireless socket at a distance exceeding the intended usage distance by
approx. 5 to 10 m. Make sure that the message is trigged by a single radio signal.
Signal LED
(no button)
Emergency
call pad
Pressure mat
Emergency call
transmitter
VarioPull
momentary
pull switch
Right-hand
button:
5 minutes ON
Left-hand
button:
ON/OFF
