2
MOUNTING
The LMPX-600 can be mounted using one of these methods:
• Mounted to a wall or corner using the included mounting wedge.
• Mounted directly to a wall, using the included ball mount
• Mounted to a j-box within a wall, using the included ball mount and ball mount plate
• Mounted to a ceiling, using the included ball mount and ball mount plate
• Mounted to a hanging threaded rod, for open ceiling environments, using the included threaded rod adapter
Mounting Bracket
Threaded hole - 3/8"-16
Threaded hole - 1/4"-20
Threaded Rod Size
3/8"-16, 1/4"-20,
or 1/2”-13
Threaded hole - 1/2"-13
Beveled edges on plate allow
for mounting into a corner
NOTE:
If mounting to a wall or corner using the mounting wedge,
the top of the wedge should be at least 1 1/2” below the
ceiling to allow the sensor room to slide down onto the
mounting plate.
SENSOR PLACEMENT
Sensor
30'
30'
Sensor
Ceiling
Ceiling Mount
1. Attach the mounting wedge to the ceiling with the two
included 1” mounting screws.
2. Align the slots of the bracket to the ribs on the
back of the LMPX-600. Then slide the LMPX-600
downward onto the mounting wedge.
Threaded Rod Mount
The threaded rod adapter can mount to a 3/8”-16, 1/4”-20, or
1/2”-13 hanging threaded rod.
1. Screw the adapter onto the rod.
2. Attach the mounting wedge to the adapter using the
included 10mm screw.
3. Align the slots of the bracket to the ribs on the back of the
LMPX-600. Then slide the LMPX-600 onto the mounting
wedge.
Unlocked
Locked
Ball Mount to Wall
1. Attach the ball mount swivel bracket to the wall
with the two included 1” mounting screws.
2. Attach the mounting wedge to the mount end of
the ball joint, using the included 10mm screw.
3. Align the slots of the bracket to the ribs on the
back of the LMPX-600. Then slide the LMPX-600
onto the mounting plate.
4. Push snug ring towards plate to adjust sensor
angle, then pull snug ring back towards sensor to
lock in place.
Pull Tab
NOTE:
Pull protective battery
tab before installation
to power the sensor.
