800.879.8585
www.legrand.us/wattstopper
No. 25101 – 11/16 rev. 1
© Copyright 2016 Legrand All Rights Reserved.
© Copyright 2016 Tous droits réservés Legrand.
© Copyright 2016 Legrand Todos los derechos reservados.
Wattstopper warranties its products to be free
of defects in materials and workmanship for a
period of five (5) years. There are no obligations
or liabilities on the part of Wattstopper for
consequential damages arising out of, or in
connection with, the use or performance of this
product or other indirect damages with respect
to loss of property, revenue or profit, or cost of
removal, installation or reinstallation.
Wattstopper garantit que ses produits sont
exempts de défauts de matériaux et de fabrication
pour une période de cinq (5) ans. Wattstopper
ne peut être tenu responsable de tout dommage
consécutif causé par ou lié à l’utilisation ou
à la performance de ce produit ou tout autre
dommage indirect lié à la perte de propriété, de
revenus, ou de profits, ou aux coûts d’enlèvement,
d’installation ou de réinstallation.
Wattstopper garantiza que sus productos
están libres de defectos en materiales y mano
de obra por un período de cinco (5) años. No
existen obligaciones ni responsabilidades por
parte de Wattstopper por daños consecuentes
que se deriven o estén relacionados con el
uso o el rendimiento de este producto u otros
daños indirectos con respecto a la pérdida
de propiedad, renta o ganancias, o al costo
de extracción, instalación o reinstalación.
WARRANTY INFORMATION
INFORMATIONS RELATIVES À LA GARANTIE
INFORMACIÓN DE LA GARANTÍA
TROUBLESHOOTING
LEDs on the remote don’t
light.
Press a button. If the LED doesn’t light:
1.
Check to see if the LED is actually lit, but very dim.
This is normal.
2.
Press the top of the paddle or any button to fully turn ON the button or paddle LED.
3.
Check batteries.
Replace if needed.
4. Remove the batteries for 5 minutes.
After 5 minutes, reinstall the batteries and try again.
The wrong lights are
controlled.
Configure the buttons to control the desired lights using the Push n’ Learn adjustment procedure.
Remote LEDs turn ON and
OFF but lights don’t change
or switch.
1.
Make sure the DLM local network is not in PnL.
2.
Be sure you’re pointing the remote at a DLM IR enabled device that is within range. To test, see
if you can put the network into PnL using the remote from your current position.
•
If successful, exit PnL and go on to step 3.
•
If not successful, move closer to the IR enabled local network device and more directly in
front of it, or try pointing toward a different IR enabled device.
3.
The scene button may be set for the same light level. Try a different button. Re-record the
scene if two scenes are duplicated.
4.
Make sure the buttons are bound to the loads you want to control. Configure the buttons to
control the desired loads using the Push n’ Learn adjustment procedure.
Button LED blinks; lights
levels don’t change.
The button is not bound to any load. Configure the buttons to control the desired loads using the
Push n’ Learn adjustment procedure.
