Tynetec, a business unit of Legrand Electric Ltd
Cowley Road, Blyth Riverside Business Park, Blyth, Northumberland, NE24 5TF.
Tel: +44 (0) 1670 352371 www.tynetec.co.uk
Trusted Technology
Caring for People
869MHz
Door Open Alarm
_________________________________________________________________________
________________________________________________________________
Doc No. FM0826 V1.06 Page 2
M
A
GNET
LED
Fit magnet in
either position
as shown here
M
A
GNET
Fit fixing screw in
bottom face as
shown here
How to install the Door Alarm
The door alarm is designed for internal use only, it is not
suitable for external applications.
Mount the door alarm using 2 screws through the rear
fixing holes or using the self-adhesive pad provided.
Fix the magnet centrally alongside on either side.
Fit the two AAA batteries observing the + polarity marking
on the PCB. The blue PCB Jumper has no function and
should be left parked on one pin as shown below…
Fit the lid and secure with the single fixing screw.
Telecare Radio ID
The door alarm includes a radio
transceiver to communicate with
the Reach IP, Advent XT2 or
Carer Response.
The Radio ID is a 10-digit code
printed on the label on the back
of the door alarm...
Registering the Door Alarm onto a Reach IP
Login to Pulse CMP (www.tynetecpulse.com) and enter the
Reach IP Serial No. in the
ALARM UNIT
view. Press the
Accessories
button and enter the Radio ID code, Location,
Equipment type and the Active Time Span.
Press
Save
then
Synchronize
.
IMPORTANT
: when the door alarm is installed a test call
must be made to check operation and start the digital
heartbeat.
Alternatively, with the Reach IP in normal operating mode
undo the fixing screw and remove the stand or connector
cover to access the
⚫
Power button.
Press the
⚫
Power button to enter Control Mode, then
press and hold the
button until the unit announces
“
add radio device
” then release.
Press the
⚫
button to confirm then activate the door
alarm by opening the door.
The Reach IP unit will sound a high beep if it’s a new
device and announce “
range test mode
”
.
Press
⚫
to confirm, or press
to step to the next
function, or press
to exit the mode.
Active time spans must be setup via Pulse CMP.
Ensure you are within an alarm time period then activate
the door alarm to check operation.
⚫
Power Button
