Doc No. FM0458 issue F Page 2
Registering a Flood Detector onto a
Reach
at-home alarm unit
1. P
ut the Reach unit into radio device learn mode…
2. Activate the flood detector
…
3.
Exit radio device learn mode…
4. Check with the Control Centre that it is convenient to perform a test call, activate the flood detector and confirm they receive a
flood alarm call.
Deleting a Flood Detector from a
Reach
at-home alarm unit
Enter
1 6 7 0
using the keypad on the rear of the Reach unit
–
the front light will
FLASH FAST GREEN
and the unit will announce
“
Program Mode - Ready
”.
Enter
# 0 4 1
and the Reach will announce “
Delete Radio Device
” followed by a “
Beep
”.
Enter the 8 digit big button ID to be deleted; after the “
Beep
” press
#
to exit.
Press the
key
to exit Program Mode; the unit will sound a “
Double-Beep
” and the fron
t light will return to
STEADY GREEN
.
The 8 digit ID can be found on a label on the top of the flood detector
–
it will always start with 80xxxxxx
The instructions given above for the standard Reach product also applies to the Reach Plus, Reach Plus GSM
and Reach Ultra models. Refer to the instruction booklets provided with these products for more information
on programming and testing radio devices.
Place a damp cloth across the 2 brass studs on the
bottom of the flood detector and the Reach will
announce “
Flood
”.
“
Trigger
Radio
Device
”
Press and HOLD the
GREEN
button on the Reach unit.
When the front light
FLASHES FAST GREEN
release the
button
and the Reach will announce
“
Trigger Radio Device
”.
You now have 1 minute to activate the flood detector.
Press the
GREEN
button on the Reach unit.
The front light will return to
STEADY GREEN
and the Reach
is back in normal operating mode.
⚫
