oPERaTion
Button and Paddle Functions
The rocker paddle has a house icon on it. Use it to begin and end binding and
scene recording functions. It can also be programmed as an ON/OFF switch,
using steps 1-3 of the Record a Whole-House Scene process described below.
Once programmed: Tap to switch or fade included devices to on (dimming
devices go to full bright). Tap to switch or fade included devices to off.
The smaller buttons, labeled A—E in the illustrations, are used to record and
recall scenes. Extra labels are provided so that you can relabel these buttons to
better suit your application.
Default Settings:
In a new DRD5, when you tap
or the E button, ALL Miro
Wireless devices in the house turn off. If, however, the new DRD5 is added to an
existing house, it acquires the same scenes as any other DRD5 or MRH5G that is
assigned to the same set of scenes (see More Scenes).
Record a Whole-House Scene
1. Go to the DRD5 and press until the LED begins flashing (about 2 seconds).
Press the desired scene button, or tap the ON/OFF paddle that you wish to
program. The LEDs on all the Wireless Miro devices begin to flash. You now
have 10 minutes to complete this process.
2. To include or exclude a device in the scene press on the device until the
LED changes color.
yellow
flashing LED = Included in the active scene
green
flashing LED = NOT included in the active scene
If you get to a device and it is NOT flashing, the 10 minute binding process
timer may have expired. Go back to step 1 and repeat.
noTE:
You must include devices that are off in the house scene if you want
them to turn off when that scene is recalled.
3. Return to the DRD5 used in step 1. Press for 2 seconds — the status LED
stops flashing, then all the status LEDs in the house revert to green.
4. Go around the house and adjust light levels by pressing and holding or
on the devices that you want to adjust.
5. Go back to the DRD5 used in step 1 and press and hold the same scene button
until the LED flashes once (about 2 seconds). Scene recording for this button
is complete. Repeat this process for each scene button.
When you see
in the instructions,
touch the top of the
paddle as directed.
When you see in the
instructions, touch the
bottom of the paddle
as directed.