Scene control
The Wireless Miro switch may be easily incorporated into room preset and whole
house preset scenes. The
Miro installation Guide
provides more information
about configuring scenes and presets.
Instructions for installation and use are included with the relevant
Miro wireless room and whole house control devices. Application
support information and the
Miro installation Guide
is available at www.legrand.
us for Legrand customers and www.vantagecontrols.com for Vantage customers.
cleAninG
Clean using a cloth dampened only with water and a little mild detergent.
Use of solvents or hydrocarbon-based cleaners may cause permanent damage.
trOubleShOOtinG
during Set house id, the led is not flashing on some Miro wireless
devices.
• If LED is solid green before initiating house ID binding:
The device already has another house ID. Reset it to the factory default so
that it can be bound to the desired house ID. Resetting to factory defaults is
described in the “I need to start over” issue.
• If LED is solid yellow after initiating house ID binding:
The device may be out of range of the initiating device. Add a MRR2G Miro
Wireless Repeater to boost signal range.
i made a configuration mistake. i need to start over.
You can reset any Miro wireless device to factory default settings by press-
ing and holding until the LED changes to solid yellow (approximately 10
seconds). During the process, the LED flashes yellow and when complete,
it changes to solid yellow. The device can then be reconfigured, exactly like
any new device (see the Set House ID section).
the switch does not work and the status led is flashing red at 2hz
(10 times in 5 seconds):
The switch has detected an overload condition and has shut down.
To clear the fault condition, tap and wait for the LED to turn green.
Disconnect loads in excess of rated load and try again.
