PRSU
Installation Instructions
8
Adjusting Stand
Tilting Display
The display can be tilted up to 15
o
either backward or forward
from a straight upright position.
1.
Turn knob counterclockwise on side of head assembly to
loosen the tilt. (See Figure 10)
Figure 10
2.
Tilt display as desired, to a maximum of 15
o
either forward
or backward.
3.
Turn knob clockwise to tighten display on head assembly.
(See Figure 10)
CAUTION:
Tighten knob on side of head assembly to
prevent damage to the stand.
4.
If leaving the display in a straight upright position, it is
recommended that a bolt (not provided) be placed through
the head assembly (See Figure 10) to lock the display into
the upright position.
Cable Management
1.
Cables may be run down either side of the stand within the
cable management flaps. (See Figure 10)
NOTE:
To prevent damage, remove cables from cable
management flaps before moving the display and also
before lowering the stand.
Figure 11
Disassembling Stand
Removing Display from Stand
1.
Rotate flags to OPEN position on two upper mounting
holes. (See Figure 12)
Figure 12
WARNING:
EACH DISPLAY MAY WEIGH IN EXCESS OF
40 LBS! Always use two people and proper lifting techniques
when installing, removing or positioning display on stand.
2.
Carefully lift display and remove from stand.
1
3
4
Place optional bolt
(not provided) here
to lock in an upright
position.
Cable
management
flaps - located
on both sides of
column
1
1
2
Содержание CHIEF PRSU
Страница 11: ...Installation Instructions PRSU 11 ...