FCS1U
Installation Instructions
8
2.
Use four connecting links (C) and cable locks (D) to secure
cables (J) to two outer frames (A). (See Figure 6)
NOTE:
If connecting turnbuckles (G) behind display, connect
turnbuckles into top holes instead of connecting links
(C). (See Figure 7)
Figure 6
Figure 7
3.
Tighten two turnbuckles (G) until cables have little to no
slack in them and use a level to make sure the mount is
level.
Display Installation
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components attached to the FCS1U mounting system
does not exceed 130 lbs (58.9 kg)
.
1.
Make sure height is at the lowest possible position.
2.
Make sure latching flags are in "open" position.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
MOUNT FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! DO NOT substitute
hardware. Only use hardware provided or specified by
manufacturer.
3.
Determine and mark the vertical center position between
the Left side Upper and Lower mounting holes in display.
(See Figure 8)
4.
Determine and mark the vertical center position between
the Right side Upper and Lower mounting holes in display.
(See Figure 8)
Figure 8
5.
Orient vertical mounting bracket (QR) so that mounting
holes are on top and mounting slots are on bottom. (See
Figure 8)
6.
Align mounting holes in vertical mounting bracket (QR) with
upper and lower mounting holes in display.
7.
Adjust vertical mounting bracket (QR) position until mark
made in Step 1 aligns with center mark in vertical mounting
bracket (QR).
(C) x 4
(D) x 4
(J) x 4
(turnbuckles
on top)
(G) x 2
(D) x 4
(J) x 4
(C) x 2
(turnbuckles
behind display)
6
3
(QR) x 2
Mounting holes
Mounting Slots