FCS1U
Installation Instructions
10
11. Determine and mark the horizontal center position between
the Left and Right
TOP
mounting holes in display.
(See Figure 11)
12. Determine and mark the horizontal center position between
the Left and Right
BOTTOM
mounting holes in display. (See
Figure 11)
13. Orient upper horizontal mounting bracket (QQ) so that
flanges are facing towards display and resting in recessed
area of left and right vertical mounting brackets (QR). (See
Figure 11)
14. Adjust Upper horizontal mounting bracket (QQ) position
until center diamond in horizontal mounting bracket (QU)
aligns with mark made in Step 9, and mounting holes and
slots in horizontal mounting bracket (QQ) are aligned with
threaded holes in mounting tabs of left and right vertical
mounting brackets (QR). (See Figure 11) and (See Figure
12)
15. Use 1/8" hex key (QP) to secure upper horizontal mounting
bracket (QQ) to left and right vertical mounting brackets
(QR) using four button head flanged screws (QN). (See
Figure 12)
16. Repeat Steps 12 through 15 for lower horizontal mounting
bracket (QQ).
IMPORTANT ! :
The orientation of, and mounting holes used,
when installing the lower horizontal mounting bracket must be
the same as the upper horizontal mounting bracket. Vertically
align upper and lower brackets by aligning holes or end of slots.
(See Figure 12)
IMPORTANT ! :
Whenever possible install mounting
screws diagonally as shown in detail in Figure 12 below.
17. Install display with attached universal interface to mount
following the installation instructions provided with the
mount.
Figure 11
12
11
(QR) x 2
Center Mark
(QQ) x 2
Figure 12
15
15
(QQ) x 2
(QR) x 2
(QN) x 8
(QR) x 2
14