Legrand Australia Pty Ltd
ABN 41 000 565 739
79-99 Hilliers Road
Auburn NSW 2144
Australia
Tel: (02) 8748 0300
Fax: (02) 8748 0345
www.legrand.com.au
204715 (24.04.09)
Product Notice
Important Notice
Legrand Australia Pty Ltd recommends and advises that only suitably qualified personnel undertake installation and maintenance of
this equipment, and that the installation complies with relevant safety and electrical standards.
Red LED On:
Green LED Off:
.
- must be performed in accordance with AS/NZS2293 for Australian and New Zealand
installations and in accordance with relevant local standards in other countries.
- Legrand Australia Pty Ltd guarantees this unit for a period of 12 months from date of despatch, solely against failure arising
from faulty materials or workmanship, and provided that the unit has been stored, shipped, installed, used and maintained in accordance
with the manufacturers instructions and relevant standards. Misuse, negligence or modification of the unit voids all warranties. Consult
Legrand Australia Pty Ltd Conditions of Sale for details on warranty liability.
If this unit is faulty, return the unit freight pre-paid to your point of purchase, or contact Legrand
Australia Pty Ltd on (61 2) 8748 0300.
- for full technical data please consult Legrand Australia Pty Ltd.
- the information and advice given should be taken as a guide only. Both are given in
good faith, and are true and correct to the best of our knowledge, though no guarantee of
accuracy is given, and thus persons receiving this information should determine its suitability.
Red LED On:
Green LED Off:
Red LED on:
Green LED on:
Indicates the WAC has enabled IRDA communications and can receive data via IrDA.
LED off:
Indicates the WAC is communicating on the Branch.
Green or Red flashing:
I
.
Red LED On:
I
.
Green LED On:
I
.
Green LED On:
Inspection and Maintenance
Warranty
Technical Data
Disclaimer
Wireless Area Controller (WAC)
Trunk or Stem LED
This LED monitors network traffic on the RS485 Backbone or Stem that links all the WACs together including any System Monitoring PCs
or PDAs.
Indicates the WAC is responding to a Stem command from a PC.
Indicates the WAC sees a command on the Stem (whether this command is for this WAC or
not)
Branch LED
IrDA LED
Emergency Test LED
Full Area Setup LED
Mains LED
Emergency Test Stop Button
WAC Installation considerations
This LED monitors data transmission between WAC and other SPUs.
Indicates the WAC is receiving data from SPUs.
Indicates the WAC is transmitting data to SPUs.
This LED monitors the infrared link communications between WAC and a PDA unit.
This LED monitors the infrared link communications between WAC and a PDA unit
ndicates certain WAC faults such as incorrect configuration data, memory corruption etc
This LED monitors the status of the Emergency Test (EM).
ndicates WAC is communicating with SPUs and when the Emergency Test,
currently in progress, has been stopped by pressing the EM Test Stop button is
pressed, or through the Aegis EM Test Stop command
ndicates the WAC is in control of the Emergency Test. It remains Green until the test is
fully completed
This LED monitors the Area Setup process.
Indicates the WAC is performing an Area Setup of any type (Full, Partial, RF or Cable).
This LED monitors Mains power to the WAC.
Red LED On:
Indicates WAC is On
The Emergency Stop button (located on the top-left side of the WAC) is used to stop Emergency Tests in progress. This button has additional
functionality for cable-only Branches. Please contact Legrand for additional information.
Keep metal bodies away from WAC and antenna must be always positioned in the vertical direction. Once the system has been
commissioned the WAC antenna must not be moved.
.
