12
REMOTE CONTROL PROGRAMMING
- 1 OR 2 REMOTES TO OPERATE 2 BASES
FIGURE 8
DUAL SYNC
CABLE
FEMALE
PLUG
MALE
PLUGS
FEMALE
PLUG
Note: Make sure both remotes are in “press & hold” mode
and both bases are flat before beginning procedure. If
using 2 remotes, both remotes must be in the same “press
& hold” or “press & release” mode.
STEP 1
Plug both bases into power source. Operate each base
with its respective remote control to verify the base
functions properly.
Lower both bases to the flat position.
STEP 6
Repeat Step 6 with BASE 2, using the remaining male
and female plugs of the dual sync cable.
STEP 7
Turn both bases over onto their legs.
CAUTION: MAKE SURE SYNC CABLE IS NOT CAUGHT
IN BASE OR PINCH POINTS.
STEP 9
Operate the remote control(s) to verify both bases function
correctly. If using only one remote control to operate both
bases, store the second remote for use as a spare.
Note: If bases do not operate in unison, make sure dual
sync cable is fully inserted into ports in control box.
Unplug both bases for 10 seconds, then plug back in.
STEP 8
Plug both bases back into power source.
STEP 5
On BASE 1, unplug the exisiting cable, shown in FIGURE
9, from the control box port. Insert one male plug of the
dual sync cable into the control box port (FIGURE 10).
Insert the removed cable into the corresponding female
plug of the dual sync cable (FIGURE 11).
STEP 2
UNPLUG both bases.
STEP 4
Locate the dual sync cable (FIGURE 8)
.
FIGURE 9
CONTROL
BOX
EXISTING
CABLE
STEP 3
Place both bases on their sides close to each other.
CAUTION: DUE TO RISK OF INJURY, TWO ADULTS ARE
3&26*3&%50)"/%-&"/%.07&"%+645"#-&#"4&
BASE 1
BASE 2
OR
REMOTE 1
REMOTE 2
FIGURE 10
CONTROL
BOX
MALE
PLUG
FEMALE
PLUG
DUAL
SYNC
CABLE
CONTROL
BOX
FEMALE
PLUG
CABLE
REMOVED
FROM
CONTROL
BOX
FIGURE 11
