BEFORE STARTING:
- Measure out and cut two 4.75” holes in the desired locations. A hole
template has been included in the kit. If lighting the entire van, it is
recommended to space the holes evenly; simply divide the length of the
ceiling liner by 3. (If the ceiling liner is 120” long, the lights should be spaced
40” apart.)
- If no ceiling liner is being installed, you will need the Legend standalone
brackets. These are attached to the ceiling supports with self-tapping
screws, which are included in the standalone kits.
- There are two lengths of cable in the kit. It is advisable to unfurl each wire
and sort them by length, as they do not come labelled. One is half the length
of the other, so it should be easy to tell them apart.
OTHER INSTALLATION NOTES:
- It is advisable to mark out where the light locations will be on the roof
of the vehicle to make routing the wires to the correct locations easier.
- Wherever possible, use the existing cable trays or gaps in the vehicle frame
to route wires. To avoid damage to cabling from ongoing use of the vehicle,
ensure that the cables are secure
d to the vehicle body
using tuck tape or
similar (not included).
IMPORTANT: Review the entire guide before starting installation.
Pictures of all components and steps are supplied to ensure correct
installation. Ensure that each connection is securely fastened and
that all wires are secured using the provided clips.
Legend Global Inc. will not accept responsibility for any damages
caused by improper installation.
Legend Light Kit Install Guide v2.2
Page 13 of 36
