Function Testing
Locating the Appliance
Note:
This model can
NOT
be hard wired.
Minimum Clearance to Combustibles
Sides............................0 inch
Floor............................0 inch
Back.............................0 inch
Top (shelf or TV)..........
8
inch
Front..........................36 inch
Electrical Supply Circuit Requirements
Please refer to section 5a. Manual Control Panel and 5b. Remote
Control to test the appliance first before insta ll a
t ion.
Should any
defects found, please contact service team for help. Call 949-
385-6588 or Email [email protected].
4.
INSTALLATION INSTRUCTIONS
Your new electric fireplace may be installed virtually anywhere in
your home. However, when choosing a location , ensure that the
general instructions for safety are followed.
For best results, install out of direct sunlight, water or very
damp air.
Power supply service must be installed within proximity of
electric fireplace prior to finishing avoiding reconstruction.
•
•
WA R N I N G ! Risk of Fire!
Keep electrical cords, drapery,
furnishings or other combustibles at least 3ft. (0.9 m) from the
front of the electric fireplace.
6
Plan the location of the appliance so that it will have adequate
electric power. A 15 AMP, 60Hz circuit is required for 120V
installation. The appliance should ideally be located close to a
suitable main socket to enable power connection.
•
