Powering Up
Power Cable
The supplied power cable will plug into a socket on the back
terminal plate of the unit. The unit has a small white plate that
indicates the voltage it is set to. If your unit’s voltage does not
match your home’s voltage contact Legacy about setting the unit
for proper voltage.
Power Switch
The power switch is on the front of the unit. Once the unit is
powered up, 5 LEDs should light up, indicating the unit is ready
for operation. Once the unit is turned off, it is not uncommon for
the LEDs to remain lit for a short period while the power supply
discharges.
Powering Up Sequence
Recommended power up sequence is source followed by
preamp/processor, then your amplifier. Powering down should be
done in reverse order.
Care
If you wish to clean your PowerBloc5, use a diluted ammonia
based window cleaner. Do not use any abrasive cleaners or
chemical solvents. Take care not to damage the aluminum
faceplate, since aluminum is a medium hardness metal and can
be scratched by the careless use of tools during the installation.
The PowerBloc5 may overheat and the finish may fade if
exposed to direct sunlight or intense heat sources for prolonged
periods.
Save your box and packing material; they may be necessary
for moving or shipping the unit for servicing by the factory.
4
Содержание PowerBloc 5
Страница 1: ......
Страница 2: ...1 Warranty 2 Designers Note 3 Rear Panel Controls 4 Powering Up Care 5 Specifications...