ASSEMBLY and INSTALLATION INFORMATION
I M P O R T A N T
BEFORE PROCEEDING, CAREFULLY READ ALL OF THE IMPORTANT SAFETY
INFORMATION CONTAINED IN THIS OWNER’S MANUAL.
Contents of Fire Pit Box – Check to be sure that you have all parts listed below:
Stainless Steel Burner
Orifice and lock nut
Connector Hose – 24”
Complete valve assembly ready to connect to gas hoses
Gas Regulator with Hose – 24”
Lava Rock – 1 Bag
Note: Your Fire Pit may be partially or completely pre-assembled. In either case please maintain these set up instructions for
future reference.
Lay out all parts and identify the corner posts [4],
connecting rails [8], nuts and washers [16 each]. Using
the supplied tools assemble the 8 rails and 4 corner
posts leaving the assembly loose at this time. The
connecting tabs will overlap at the corner posts. Each of
the connecting rail tabs will fit over two studs.
The side panels are held in place magnetically. Attach the four side panels at this time to the magnets on the corner posts. One of
the side panels has a gas valve mounting hole and a clip at the top. Install the black retaining clip from the parts bag over the
connecting rail and the side panel. This is to prevent the side with the gas valve from moving. Place the chrome flange through the
hole from the outside. Place the plastic sleeve over the valve and thread the valve on to the mounting flange.
The top panels comes in two pieces. Using
the long bolts, nuts, & washers assemble
the two halves and bolt them together
tightly. The washers fit on the bolt head
side of the assembly. When completed
place the top on the base.
