D
C
Button position
Set horizontal –
or slightly lower
Minimum
temperature
Maximum
temperature
Safe temperature
(see ‘setting safe
temperature’ section)
(button alignment)
Safe temperature locator
Safe temperature position
E
9
Temperature stop (D) orientation
Once the safe operating temperature has been set, the next stage is to correctly assemble the
temperature stop (D) & override (C). The temperature stop and ‘safe temperature’ button can be
positioned to customer requirements. The below setting is suitable for right handed operation.
Three typical settings are shown on the next page.
FITTING THE ‘TEMPERATURE OVERRIDE’
1
Locate the temperature stop (D) onto the
cartridge spline with the ‘safe temperature’
locator in a horizontal or slightly lower position.
This is dependent on the orientation of the
splines (as shown above). Do not set higher as
this will effect the position of the button on the
override (C). Once located in a suitable position
push the temperature stop in fully.
2
Locate the override (C) with the button
positioned horizontally and to the left. Slide the
override carefully onto the smaller cartridge
spline. There may be a small amount of rotation
required to align the override mechanism with
the safe temperature position.
Note: The button may not be perfectly
horizontal depending on the orientation of the
cartridge splines.
3
Secure with screw (E). It is important to check
the water temperature.
4
Fit the temperature control handwheel (A) then
tighten set screw (B) using a 1.5mm hexagonal
key to secure.
