LA02303B BLE Module Specification
www.leedarson.com
▏
Better Life with Better IoT Innovation 19 / 20
entre le radiateur et votre corps.
Notice to OEM integrator
Must use the device only in host devices that meet the FCC/ISED RF exposure category of mobile,
which means the device is installed and used at distances of at least 20cm from persons.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
The end user manual shall include FCC Part 15 /ISED RSS GEN compliance statements related to the
transmitter as show in this manual(FCC/IC Canada statement).
Host manufacturer is responsible for compliance of the host system with module installed with all
other applicable requirements for the system such as Part 15 B, ICES 003.
Host manufacturer is strongly recommended to confirm compliance with FCC/ISED requirements for
the transmitter when the module is installed in the host.
The use condition limitations extend to professional users, then instructions must state that this
information also extends to the host manufacturer’s instruction manual.
This module is stand-alone modular. If the end product will involve the multiple simultaneously
transmitting condition or different operational conditions for a stand-alone modular transmitter in a
host, host manufacturer have to consult with module manufacturer for the installation method in
end system.
Any company of the host device which install this modular should perform the test of radiated &
conducted emission and spurious emission etc. according to FCC Part 15C: 15.247 and 15.209 &
15.207, 15B class B requirement, only if the test result comply with FCC part 15C: 15.247 and
15.209 & 15.207, 15B class B requirement. Then the host can be sold legally.
This modular transmitter is only FCC authorized for the specific rule parts (47CFR Part 15.247
and 15.407) listed on the grant, and that the host product manufacturer is responsible for
compliance to any other FCC rules that apply to the host not covered by the modular transmitter
grant of certification.
Host manufacturer is strongly recommended to confirm compliance with FCC/ISED
requirements for the transmitter when the module is installed in the host.
Must have on the host device a label showing Contains FCC ID: 2AB2Q-LA02303B or IC: 10256A-
LA02303B
Both FCC ID and IC ID are not to be placed on the host at the same time and only hosts going into the
US can use the FCC ID and only hosts going into Canada can use the IC ID.
Antenna: PCB Antenna & 4 dBi
l'hôte doit utiliser l'instrument uniquement dans des dispositifs qui répondent à la fcc / (catégorie
d'exposition rf mobile, ce qui signifie le dispositif est installé et utilisé à une distance d'au moins 20
