5
6. Installation Guide
1.
The sensor will be in pairing status when power turns on for the first time. This will cause an
LED indicator light to flash once per second for 3 minutes. Use the LEEDARSON Application to
search for this device
.
If sensor pairs successfully, the light will stop blinking and then stay on for
about 10 seconds.
2.
Install the detector where there is a concern for a potential water leak.
7. Product usage
1. Insert 2 pcs AAA
battery to the battery space, and the water leak sensor will be ready for use.
2. How to reset a water leak sensor
A.
Press and hold the reset key on the bottom cover for about 3 seconds, then the LED
(signal light) will start blinking quickly.
B.
Release the reset key and the sensor will be reset to factory settings and the LED(signal
light) blinks once per second to search for a new enabled Zigbee network.
3. How to pair a water leak sensor
A.
After the sensor reset to factory settings, the LED(signal light) blinks once per second and
sensor starts searching an enabled Zigbee network.
B.
If sensor pairs successfully, it will stop blinking and the light will stay on for 10 seconds
C.
If no available networks were found within 3 minutes, the LED will stop blinking and turn
off.
Tip: When initially setting up the LEEDARSON Water Leak Sensor, it is recommended to perform the
setup task within 15 feet (4.5 meters) of the Zigbee Hub.
