LeeBoy 8510b, Руководство по эксплуатации и обслуживанию

Страница: 76 / 320

6-18 LeeBoy Model 8510B Conveyor Paver
Operation
Loading
Paver must be loaded screed end first
to prevent damage. If the paver is loaded hopper end
first, the weight of the operator on the walkway will
tend to tip the paver onto the screed (Figure 6-18).
1. Move paver to base of ramp. Line up tracks with the
ramp.
2. Make sure of the following:
a. Screed position is - UP
b. Extendable screed - IN
c. Gates below auger - CLOSED
Never back up with cutoff gates open.
Incorrect Loading Position
Figure 6-18
NOTE: Always have a helper on the ground that can
assist the operator in moving the paver onto the
transport.
To prevent an excessive jolt to the
undercarriage and throughout the paver, reduce
traveling speeds to a minimum before the paver
tracks come in contact with loading ramps or an
abrupt change in the surface. If encountered, the
track drive sprocket or possible other components
may be damaged because of the excessive jolt.
3. Load paver screed end first. Set throttle at 1/2
operating RPM so paver moves very slowly onto the
ramp.
4. With the steering control lever slowly guide the
paver up the ramp.
5. Place paver in center of trailer or desired position.
6. Lower screed to deck.
7. Shut down engine.
8. Secure paver to transport as directed by
regulations.
NOTE: Always keep up to date with changes in local
and federal regulations for tie down and
transportation of equipment.
Tie Down Procedure
1. Position paver on trailer centered from side to side
(Figure 6-19) .
Paver On Transport
Figure 6-19
2. Attach tie down chains to the hopper end of paver at
the D-rings on all sides.
3. Attach tie down chains to the screed end of paver at
the D-rings (-Figure 6-20) .
4. Place chocks at wheels or tracks.
5. Make sure all chains are tight before moving.
Tie Down Points
Figure 6-20
NOTE: Always keep up to date with changes in local
and federal regulations for tie down and
transportation of equipment.
Return to
Last Viewed
Return to
Thumb Index